Installation - Premium Pad To Mounting Hardware - Permobil Comfort M2 BodiLink LPTS Operation Manual

INSTALLATION - PREMIUM PAD TO MOUNTING HARDWARE

For any Premium pad and TT or GT hardware styles. All required tools are provided.
In some cases, the pad will come installed on the hardware.
1
Unzip and remove the cover and foam insert to gain access to the metal tracks (A) for hardware installation. Remove the
plastic cap (if installed). Insert the two square nuts (B) into each of the two pad tracks (A).
2
Line up the bolts (C), safety washers (D), and slots on the mounting bracket (E) with square nuts (B) in track (A).
Recommendation: If one hardware assembly is being used per pad, install the hardware closer to the center of the pad (depth).
If two hardware assemblies are being assembled onto one pad, install one hardware assembly towards the front and one
towards the rear of the pad.
3
Tighten the bolts (C) using the 5mm hex key. Reinstall the plastic cap (if provided).
4
Replace the cover by inserting the foam insert in the cover with the gripping side of the foam facing the support pad,
and then add in the support pad and zip the cover closed.
3.5"L x 8"D Premium Pad and
Power Mount TT Hardware Shown
3.5"L x 8"D Premium Pad with
multiple sets of TT Hardware Shown
BodiLink Lateral Trunk Support Operation Manual
B
5
A
E
D
C