pagertec TRACKSTAFF V3 User Manual page 4

TrackStaff V3
Installing the Transmitter
The first consideration in the placement of the transmitter is convenience. It should be readily
accessible in a central location within the paging area. Pay close attention to nearby
obstructions such as walls, pipes, ducts, mirrored glass, or other similar barriers that may
weaken or misdirect transmitted signals. Certain materials and construction, especially metal,
have the potential to partially or completely block the paging signal.
The next consideration involves safety. Ensure the unit is securely mounted and away from
liquids, extreme heat and possible physical damage. Also remember that the transmitting unit
requires a 110V AC power outlet. Be sure an antenna is attached prior to applying power to
avoid damage to the transmitter.
For best results, the transmitter antenna must be vertical. Ideally the transmitter should be
centrally located within the area where paging is to occur. Since this is not always possible,
range testing at different locations may be required to obtain the desired performance.
Once the Desktop Transmitter and antenna have been installed, plug in the power adapter.
Once powered the transmitter will display
We recommend some type of surge suppressor on the power supply for protection. Power
surges are not covered under system warranty.
"Enter Pager'' indicating it is ready to send a page.
4