Battery Installation; Operation - pagertec TRACKSTAFF V3 User Manual

1. Remove a pager from the charging station. Pagers will light up to signal they have power.
2. Record the name of the staff member next to the pager number. (Use dry erase marker)
3. Press the number on the transmitter of the pager you wish to activate
4. Pager will Vibrate, Flash, and or Beep depending on the alert mode.
5. To silence the pager you can press the sde button or set the pager back on the charger.

BATTERY INSTALLATION

The rechargeable nickel metal hydride (NiMH) batteries will typically last from one to three
years depending on usage. To replace the batteries , first remove the back lid screw using a
small Phillips head screwdriver. Lift the back lid from the front of the pager. Place the front
housing of the pager in a safe place for closure after changing the rechargeable batteries.
Next, carefully remove the old batteries. Place in the new replacement batteries (2 AAA NiMH
batteries) caution make sure to put the batteries in the correct direction following the (+ and -)
instructions on the pager. Replace the front housing and re-secure it back in place using the
Phillips head set screw.

OPERATION

6