Joy-it COM-ZYPDS Manual

Usb-pd trigger module

USB-PD TRIGGER MODULE

COM-ZYPDS

1. GENERAL INFORMATION

Dear customer,

Thank you for purchasing our product. In the following, we will show you

which things should be noted during the use.

Should you encounter any unexpected problems, do not hesitate to

All three items have the same circuit board and differ only in the output

interface.

When using the modules, make sure to use a sufficient cable

cross-section.

To use the modules as intended, you need a USB-PD-capable power

supply unit.

Table of Contents

Do you have a question about the COM-ZYPDS and is the answer not in the manual?

Page 1 USB-PD TRIGGER MODULE COM-ZYPDS 1. GENERAL INFORMATION Dear customer, Thank you for purchasing our product. In the following, we will show you which things should be noted during the use. Should you encounter any unexpected problems, do not hesitate to contact us.
Page 2 2. INTERFACE 3. OPERATION Connect your USB-PD trigger module to a USB-PD capable power supply using the USB-C connector. These modules provide you with different voltage modes. The mode can be changed by re-soldering a resistor. Attention : Unsoldering the resistors is not easy for the unpractised due to the very small size of the resistors (0.6 mm x 0.3 mm).
Page 3 We will send you a parcel stamp with which you can send us your old appliance free of charge. For this possibility, please contact us via e-mail at service@joy-it.net or via telephone. Information about Package: Please package your old appliance safe for transport. Should you not...