Joy-it COM-ZY12PDG Manual

Usb-pd trigger module

USB-PD TRIGGER MODULE

COM-ZY12PDG

1. GENERAL INFORMATION

Dear customer,

Thank you for purchasing our product. In the following, we will show you

which things should be noted during the use.

Should you encounter any unexpected problems, do not hesitate to

When using the module, make sure to use a sufficient cable

cross-section.

To use the module as intended, you need a USB-PD-capable power

supply unit.

Table of Contents

Do you have a question about the COM-ZY12PDG and is the answer not in the manual?

Page 1 USB-PD TRIGGER MODULE COM-ZY12PDG 1. GENERAL INFORMATION Dear customer, Thank you for purchasing our product. In the following, we will show you which things should be noted during the use. Should you encounter any unexpected problems, do not hesitate to contact us.
Page 2 2. INTERFACE Trigger pin USB Type-C Ground VBUS Ground VBUS The trigger pin on the board has the same function as the button. By set- ting the pin LOW, pressing the button is simulated.
Page 3 3. OPERATION Connect your USB-PD trigger module to a USB-PD compatible power supply using the interface explained above. The free solder pads on the back of the board are used to connect the load. These modules provide you with different voltage modes, which are indicated by the LED. Colour Voltage mode ■...
Page 4 We will send you a parcel stamp with which you can send us your old appliance free of charge. For this possibility, please contact us via e-mail at service@joy-it.net or via telephone. Information about Package: Please package your old appliance safe for transport. Should you not...