Philio PHI PST02-1C Quick Start Manual page 6

Operation mode. Using bit to control.
Size: 1 Byte, Default Value: 0
Setting
1
2
4
8
16
32
64
128
Parameter 6: Mult-Sensor Function Switch
Multisensor function switch. Using bit to control.
Size: 1 Byte, Default Value: 4
Setting
1
2
4
8
16
32
64
128
Parameter 7: Customer Function
Customer function switch, using bit control.
Size: 1 Byte, Default Value: 4
Setting
1
2
4
8
16
32
64
128
Parameter 8: PIR Re-Detect Interval Time
In the normal mode, after the PIR motion detected, setting the re-detect time. 8 seconds per tick, default tick is 3 (24 seconds).Setting the suitable value to
received the trigger signal too frequently. Also can save the battery energy.Notice: If this value bigger than the configuration setting NO. 9. There is a period
light turned off and the PIR not start detecting.
Size: 1 Byte, Default Value: 3
Setting
1 - 127
http://manual.zwave.eu/backend/make.php?lang=en&sku=PHI_PST02-1C
Description
Reserve.
1 means test mode, 0 means normal mode. Notice: This bit only effect by the DIP Switch setting to "cust
mode", otherwise it decides by DIP Switch setting to Test or Normal Mode
Disable the door/window function. (1:Disable, 0:Enable)
Setting the temperature scale. 0: Fahrenheit, 1:Celsius
Disable the illumination report after event triggered. (1:Disable, 0:Enable)
Disable the temperature report after event triggered. (1:Disable, 0:Enable)
Reserve.
Disable the back key release into test mode. (1:Disable, 0:Enable)
Description
Disable magnetic integrate illumination to turn ON the lighting nodes in the association group 2. (1:Disab
0:Enable)
Reserve.
Reserve.
Reserve.
Disable delay 5 seconds to turn off the light, when door/window closed. (1:Disable, 0:Enable)
Disable auto turn off the light, after door/window opened to turn on the light. (1:Disable, 0:Enable)
Reserve.
Reserve.
Description
Reserve.
Reserve.
Reserve.
Disable send out BASIC OFF after door closed. (1:Disable, 0:Enable)
Notification Type, 0: Using Notification Report. 1: Using Sensor Binary Report.
Disable Multi CC in auto report. (1:Disable, 0:Enable)
Disable to report battery state when the device triggered. (1:Disable, 0:Enable)
Reserve.
Description
PIR Re-Detect Interval Time
06-10-2020 15:11
Pagina 6 van 9