Philips sonicare Manual page 28

28
English
1
2
2 Remove and discard the brush head. Cover
the entire handle with a towel or cloth.
3 Hold the top of the handle with one hand
and strike the handle housing 0.5 inch
above the bottom end. Strike firmly with a
hammer on all 4 sides to eject the end cap.
Note: You may have to hit on the end
several times to break the internal snap
connections.
4 Remove the end cap from the toothbrush
handle. If the end cap does not release
easily from the housing, repeat step 3 until
the end cap is released.
5 Holding the handle upside down, press the
shaft down on a hard surface. If the internal
components do not easily release from the
housing, repeat step 3 until the internal
components are released.
6 Wedge the screwdriver between the battery
and the black frame at the bottom of the
internal components. Then pry the
screwdriver away from the battery to break
the bottom of the black frame.