Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for elvita CTM3714V
Summary of Contents for elvita CTM3714V
- Page 1 User manual Washing machine CTM3714V...
- Page 2 Thank you for your trust and the purchase of our product. This user manual is supplied to help you use this product. The instructions should allow you to learn about your new product as quickly as possible. Make sure you have received an undamaged product. If you do find transport damage, please contact the seller from which you purchased the product, or the regional warehouse from which it was supplied.
- Page 3 Warranty Warranty Consumer warranty regarding quality of product applies. © 2021, Elon Group AB. All rights reserved.
-
Page 4: Table Of Contents
Contents Contents SAFETY Admonitions ..........................Intended use ..........................Safety for children and people with disabilities................ General safety........................... Safety during installation ......................Safety during operation ......................Safety during maintenance ...................... Disposal............................. QUICK START GETTING STARTED Installation..........................Getting to know your washing machine................... Controls.............................. - Page 5 Contents CLEANING Clean the exterior........................Clean the detergent dispenser....................Clean the drum ......................... Clean the door seal and glass ....................Clean the tap inlet filter......................Clean the machine inlet filter ....................Clean the drain pump filter ....................... TROUBLESHOOTING Troubleshooting......................... INSTALLATION Installation area ........................
-
Page 6: Safety
Safety SAFETY Carefully read the instructions before you install and use the product. Save the instructions and keep them near the product for future reference. All kinds of warranties shall be invalid if these instructions are not followed. Admonitions WARNING! Used when there is a risk for personal injury. -
Page 7: General Safety
Safety General safety WARNING! • Do not wash or dry articles that have been cleaned in, washed in, soaked in, or dabbed with combustible or explosive substances, such as wax, oil, paint, gasoline, degreasers, dry cleaning solvents, kerosene, etc. This may result in fire or explosion. •... -
Page 8: Safety During Operation
Safety WARNING! • Make sure that the product is connected to water and electrical supplies by a suitably qualified person in accordance with the manufacturer’s instructions and local safety regulations. • If the power cord is damaged, it must be replaced by the manufacturer, the manufacturer’s service agent or similarly qualified persons in order to avoid a hazard. -
Page 9: Safety During Maintenance
Safety CAUTION! • Before washing laundry items the first time, a washing programme must be run to completion without any items in the drum. Safety during maintenance WARNING! • Only authorised technicians may carry out repairs. • If you experience problems with the product that the troubleshooting information in the complete manual cannot help you solve, turn off the product, unplug it from the power supply, turn off the water supply, and contact our support and service. -
Page 10: Quick Start
Quick start QUICK START Before washing Washing After washing © 2021, Elon Group AB. All rights reserved. -
Page 11: Getting Started
Getting started GETTING STARTED Installation See section "Installation", page 27 Getting to know your washing machine Controls A. Speed wash programmes B. Programme selector C. Time D. Door lock E. Child lock F. Start/Pause G. Options, settings and functions Detergent dispenser A. -
Page 12: Accessories
Getting started Accessories A. Transport hole plugs B. Transport bolts C. Drain hose holder D. Water supply hose Transport hole plugs For plugging the holes after the transport bolts have been removed. Transport bolts For securing the machine during transport. Drain hose holder For securing the hose and avoiding kinks, for example when placing the hose over the edge of a sink. -
Page 13: Before First Use
Getting started Before first use Run an empty washing cycle Make sure that the machine is installed properly. Plug in the power cord. 2. Open the water tap. 3. Start a washing programme. NOTE! Do not put any clothes in the machine. The machine is ready for use when the programme has completed. -
Page 14: Washing
Washing WASHING Before each wash Check the clothing care labels. 2. Remove any items from the pockets. CAUTION! Sharp and rigid items, such as coins, brooches, nails, screws or stones etc., may cause serious damage to this washing machine. 3. Tie any belts and fasten any zips or buttons. 4. -
Page 15: Options, Settings And Functions
Washing 4. Add detergent and softener in the detergent dispenser if needed. NOTE! Make sure to use a detergent suitable for the the laundry to be washed and the selected washing programme and temperature. 5. Press to start the programme. When the washing is completed an acoustic signal sounds and End is displayed. -
Page 16: Use The Extra Rinse Option
Washing Use the Extra rinse option Turn the programme selector to select a programme. 2. Press 3. Press Mute and unmute the acoustic signal NOTE! The acoustic signal will not sound when it is muted. Press and hold for 3 seconds to mute the acoustic signal. 2. -
Page 17: Cotton
Washing Cotton For hard-wearing, heat-resistant textiles made of cotton or linen. Temperature and time 30 °C 2:40 40 °C 2:40 60 °C 2:45 90 °C 2:50 Default speed 1400 rpm Maximum load, washing 7.0 kg Pre-wash detergent Main wash detergent Essential Softener Optional Options • Delay •... -
Page 18: Drain Only
Washing Drain only Drain off the water. Default temperature Default time 0:01 Default speed Maximum load, washing Pre-wash detergent Main wash detergent Softener Drum clean Clean the drum of the machine at 90 °C. Not to be used for laundry. To increase the cleaning effect, you can use a chlorine bleaching agent intended for washing machines. Follow the instructions included with the bleaching agent. -
Page 19: Mix
Washing Mixed load consisting of textiles made of cotton and synthetics. Temperature and time Cold 0:59 40 °C 0:59 60 °C 1:11 Default speed 1400 rpm Maximum load, washing 7.0 kg Pre-wash detergent Main wash detergent Essential Softener Optional Options • Delay • Extra rinse Rinse &... -
Page 20: Spin Only
Washing Spin only Extra spinning with selectable spin speed. Default temperature Default time 0:12 Default speed 1400 rpm Maximum load, washing 7.0 kg Pre-wash detergent Main wash detergent Softener Options • Delay Synthetic For washing synthetic items, such as shirts, coats and blended fabrics. When knitted garments are washed the amount of detergent should be reduced to avoid excessive foaming. -
Page 21: Cleaning
Cleaning CLEANING Correct maintenance of your product can extend its working life. When needed, use a limescale remover intended for washing machines. Follow the instructions included with the remover. WARNING! Unplug the machine and close the tap before starting maintenance. CAUTION! Do not use alcohol, solvents or chemical products to clean the product. -
Page 22: Clean The Door Seal And Glass
Cleaning • When needed, run the programme intended for cleaning the drum. See section "Drum clean", page 18 Clean the door seal and glass Do this after each wash. • Wipe the glass and seal to remove lint and stains. NOTE! If lint builds up it can cause leaks. -
Page 23: Clean The Machine Inlet Filter
Cleaning Turn off the tap and remove the water supply hose from the tap. 2. Clean the filter. 3. Refit the water supply hose to the tap and turn on the tap. Clean the machine inlet filter The machine inlet filter must be cleaned if the water supply becomes restricted. Turn off the tap and unscrew the inlet pipe from the rear of the machine. - Page 24 Cleaning Open the filter cover. 2. Rotate the filter anticlockwise and pull it out. 3. Remove any foreign objects. 4. Refit the filter and close the cover. CAUTION! Make sure the valve cap is reinstalled properly; fittings must be correctly aligned otherwise water may leak. ©...
-
Page 25: Troubleshooting
Troubleshooting TROUBLESHOOTING Troubleshooting WARNING! • Only authorised technicians may carry out repairs. • If you experience problems with the product, please see if the user instructions and troubleshooting information in the user manual can help you find a solution. If the problem persists: –... - Page 26 Troubleshooting NOTE! If your machine needs repair, consider repairing it. Repairing instead of buying new is good for the environment. The spare parts listed in the EU regulation 2019/2023 will be available to professional repairers at lest 10 years after this product was placed on the market. ©...
-
Page 27: Installation
Installation INSTALLATION Follow the instructions in this section to install your machine. WARNING! • If the power cord is damaged, it must be replaced by the manufacturer, the manufacturer’s service agent or similarly qualified persons in order to avoid a hazard. •... -
Page 28: Unpack The Machine
Installation WARNING! • Make sure that the machine does not stand on the power cord. • The plug must be accessible after installation. WARNING! The machine must not be used in very wet rooms or rooms where there is a risk of explosive or caustic gases. CAUTION! •... -
Page 29: Remove The Transport Bolts
Installation 4. Remove the tape holding the power cord and drain hose. 5. Remove the accessories from the drum. WARNING! Keep all packaging material well away from children. There is a risk of suffocation! Remove the transport bolts WARNING! You must remove the transport bolts from the rear before using the machine. Loosen the bolts with a spanner and remove them. -
Page 30: Level The Machine
Installation Level the machine Loosen the nuts and screw in the feet fully. Check if there are any feet not touching the floor. 2. If any foot is not touching the floor: screw out the foot until it makes contact with the floor. 3. -
Page 31: Connect The Water Supply Hose To The Machine
Installation Connect the water supply hose to the machine Lift the supply hose to the inlet valve at the rear of the machine. 2. Screw the coupling onto the threads of the tap until tight. Connect to an external drain CAUTION! •... -
Page 32: Connect The Drain Hose To A Sink Drain Pipe
Installation Connect the drain hose to a sink drain pipe Position the drain hose into a sink Use the drain hose holder to keep the drain hose bent downward into the sink without kinking. © 2021, Elon Group AB. All rights reserved. - Page 33 Installation Remove the drain hose carefully from the clasps. 2. Insert the drain hose into the hose holder. 3. Hang the hose holder over the edge of the sink. 4. Secure the drain hose to the sink with a cord, clip or cable tie. ©...
-
Page 34: Appendix
Appendix APPENDIX Technical specifications NOTE! The value of rated capacity refers to the weight of dry laundry. Model code See section "Find the model code", page 12 Width 595 mm Depth 495 mm Height 850 mm Weight 60 kg Rated capacity 7 kg Maximum spin speed 1400 rpm Power supply 220-240 V, 50 Hz... -
Page 35: Eu Directives And Standards
Appendix Programme Washing load Programme Energy Water Max. Remaining at which the duration consumption consumption temperature moisture values were (hours:minutes) (kWh per cycle) (litres per cycle) reached for content and the achieved (rated min. 5 minutes spin speed capacity of the inside the (rpm) at which specific... - Page 36 Elvita products are distributed and marketed by Elon Group AB. Elon Group AB Bäcklundavägen 1 | 702 03 Örebro Sweden ELON GROUP | +46(0)10-220 40 00 | ELONGROUP.SE Support and service: ELVITA.SE...
Need help?
Do you have a question about the CTM3714V and is the answer not in the manual?
Questions and answers