How To Activate The Battery; Important Maintenance Instruction - netvox R718IA User Manual

Wireless 0-5v adc sampling interface

Hide thumbs Also See for R718IA:

Table of Contents

6.2 How to activate the battery

a. Connect a battery to a 68ohm resistor in parallel

b. Keep the connection for 6~8 minutes

c. The voltage of the circuit should be ≧3.3V

Kindly pay attention to the following in order to achieve the best maintenance of the product:

• Keep the device dry. Rain, moisture, or any liquid, might contain minerals and thus corrode electronic circuits.

If the device gets wet, please dry it completely.

• Do not use or store the device in dusty or dirty environment. It might damage its detachable parts and

electronic components.

• Do not store the device under excessive heat condition. High temperature can shorten the life of electronic

devices, destroy batteries, and deform or melt some plastic parts.

• Do not store the device in places that are too cold. Otherwise, when the temperature rises to normal

temperature, moisture will form inside, which will destroy the board.

• Do not throw, knock or shake the device. Rough handling of equipment can destroy internal circuit boards

and delicate structures.

• Do not clean the device with strong chemicals, detergents or strong detergents.

• Do not apply the device with paint. Smudges might block in the device and affect the operation.

• Do not throw the battery into the fire, or the battery will explode. Damaged batteries may also explode.

All of the above applies to your device, battery and accessories. If any device is not working properly, please

take it to the nearest authorized service facility for repair.

Table of Contents