Table of Contents
Advertisement
MF1-Rear
1 Identification
The MF1-Rear is part of the MFS-V3 wire feeder system and is used in industry and the trade for the delivery of welding
wire or solder. The MF1-Rear is a 4-roll wire drive that is solely used as the rear drive for feeding the wire in push-push
mode. All other media (coolant, shielding gas, welding current) required for the joining process must be separately supplied.
These operating instructions only describe the MF1-Rear master feeder. The MF1-Rear must only be operated using
original ABICOR BINZEL spare parts.
1.1 Marking
This product fulfills the requirements that apply to the market to which it has been introduced. A corresponding marking has
been affixed to the product, if required.
2 Safety
The enclosed safety instructions must be observed.
2.1 Designated use
• The device described in these instructions may be used only for the purpose described in these instructions in the manner
described. In doing so, observe the operating, maintenance and servicing conditions.
• Any other use is considered improper.
• Unauthorized conversions or power increase modifications are not permitted.
2.2 Obligations of the operator
• Keep the operating instructions within easy reach at the device for reference and enclose the operating instructions
when handing over the product.
• Putting into operation, operating and maintenance work may only be carried out by qualified personnel. Qualified
personnel are persons who, based on their special training, knowledge, experience and due to their knowledge of the
relevant standards, are able to assess the tasks assigned to them and identify possible dangers
(in Germany see TRBS 1203).
• Keep other persons out of the work area.
• Please observe the accident prevention regulations of the country in question.
• Ensure good lighting of the work area and keep the work area clean.
• Occupational health and safety regulations of the country in question. For example, Germany: Protection Law and the
Company Safety Ordinance
• Regulations on occupational safety and accident prevention
2.3 Personal protective equipment (PPE)
To avoid danger to the user, these instructions recommend the use of personal protective equipment (PPE).
• This consists of protective clothing, safety goggles, a class P3 respiratory mask, protective gloves, and safety shoes.
BAL.0442.0 • 2021-10-21
1 Identification
EN - 3
Advertisement
Table of Contents
