OneAdvisor-1000 Portable Network Tester
QUICK CARD
R U N T E S T
Press the Start soft key
1.
After auto-configuration, the OTDR will perform
a connection check to ensure that the
connection is Good. If the Connection is Bad,
disconnect the launch cable, and reconnect as
described on pages 1 and 2, cleaning every fiber
that fails the inspection test.
The OTDR will perform an acquisition at the
2.
configured wavelength.
V I E W S M A RT L I N K M A P
Tap the SmartLink tab at the left screen top to
1.
select SmartLink view.
Set the toggle switch at the right screen top to
2.
Event Line.
View SmartLink results:
3.
The FUT is displayed as a series of icons
►
representing events (front connector,
launch cable, connectors, splices, bends,
etc.) and distances. Swipe left or right to
view additional icons on spans with more
than 4 events.
The center of the display shows summary
►
results for the entire span for each
acquisition or wavelength. Tap any event
in the upper display to view detailed results
for that specific event.
Events are marked with a green check or
►
red
x
based on the Alarms setting.
Note: the icon-based view may not be
available on older ONA-1000s when
acquisition Mode = SmartAcq. Rerun the test
with Mode = Auto or contact VIAVI to upgrade
your unit to add this feature.
OneAdvisor-1000 Portable Network Tester
to start the test.
VIAVI//Public
Figure 10: Connection Check
Figure 11: SmartLink View, Summary Results
Figure 12: SmartLink View, Event Results
4