Viewing And Deleting Stored Data - Kanomax ANEMOMASTER A031 Operation Manual

5.3 Viewing and Deleting Stored Data

The average, maximum and minimum value of the stored data can be viewed on the display and deleted. Only the
calculation result can be viewed from the instrument. To view each data of the data group, the data must be printed
out from an optional printer (please refer to section 7 "Data Output" P.19).
When deleting the stored data, the calculation result and each data of the selected data group will be deleted.
Data viewing and deleting procedure will be described below by taking an example of an operation in the "Air
Velocity / Air Temperature Measurement Mode".
Display
①
②
③
④
⑤
< Viewing the Stored Data >
Press the key when the instrument is in the measurement
mode in which the data is stored.
The most recently stored average value (AVG) will be displayed.
(Figure ②)
< Viewing Other Data >
By pressing the
the data group can be viewed.
To move to the previous/next data group, press the
< Exit from Data Viewing >
Press the key to exit (cancel) data viewing.
When cancelled, the screen will return to the measurement mode.
(Figure ①)
< Deleting the Stored Data Group >
Select the data group (Figure③) to be deleted, and press the
key. The air velocity value will start blinking (Figure④).
- To delete the selected data, press the
will be displayed (Figure ⑤).
- To delete All data groups stored in the relevant measurement mode,
press and hold the
displayed. All Data Groups stored under this mode will be cleared.
After is displayed, the screen will return to the measurement
mode.
17
Description
key, maximum, minimum and average value of
key again. When pressed,
key for approx. 5 seconds until
▲
▼ keys.
is