Selecting Deko2408 Or 2409 - Dekolink DEKO2408 Product Manual

P M
RODUCT ANUAL
6.5 S D
ELECTING
6.5.1 General
Once the main screen is loaded, you are required to enter the identification data
of the Mini-Repeater and its default parameter values. The Mini-Repeater is set
to download the data automatically when the PC connects to it, or you can
select the unit manually and then connect to the Mini-Repeater.
The standard procedure is first to connect automatically (see paragraph 6.5.2),
and if unsuccessful, selecting the Mini-Repeater manually (see paragraph
6.5.3). Proceed as follows:
6.5.2 Automatic Selection of Mini-Repeater
To connect initiate a local setup session:
1. Press the Connect button at the bottom of Controls and Parameters
screen
2. The Deko-RMS software initiates a communication session with the
Mini-Repeater
3. Watch the unit connection procedure. When the connection is reached
the upper window rectangle in the main screen is colored green.
4. The identification window displays the name of the connected
Mini-Repeater
5. The Mini-Repeater can now be setup from the Workstation.
The Mini-Repeater will stay online until forced to disconnect by pressing the
Disconnect button on its configuration screen.
Once you have finalized the connection procedures, you can operate
theDeko2408 or Deko2409. These procedures are provided in the next section.
Page 22
M R
INI EPEATER
2408 2409
EKO OR
Establishing the connection may take up to 1 minute.
D 2408-09
EKO
Note
Proprietary Data
D W L
EKOLINK IRELESS TD
Pub. 308-2005 Rev. 2.00S
.