D
W
EKOLINK
IRELESS
6.6 M
-R
INI
EPEATER
6.6.1 General
This section provides the setup and monitoring procedures for Mini-Repeater
Deko2408-09. The Mini-Repeater setup consists of entering the operational
parameters of the unit.
Operation of Mini-Repeater Deko2408-09 includes:
•
Setting the Controls and Parameters fields
•
Checking the Configuration data
•
Verifying the Alarms status
•
Verifying the operating parameters.
6.6.2 Setting the Controls and Parameters Fields
Proceed as follows:
1. Click on the Controls and Parameters tab (see Figure 15)
2. Check that the main operational boxes are on for proper operation
(see Figure 16)
3. Optional - Press the Get Parameters button to pull out the parameters
values from the Mini-Repeater (last setup values) – (see Figure 15)
4. Select and verify the values for the main parameters in the Link and
Smart ALC data fields (see Figure 16 to Figure 18)
5. Check the values of the measured parameters as shown in the
Measurement data fields, and determine the mode of selection for
Downlink amplification (see Figure 18)
6. Press the Send Parameters button to enter and save the selected
operational values in the Mini-Repeater
Whenever you select a new value, its display turns red until you finalize all
the procedures and the Mini-Repeater is set to the new values.
Pub. 308-2005 Rev. 2.00S
L
.
M
R
TD
INI
EPEATER
S
ETUP
D
2408-09
EKO
Note
Proprietary Data
P
M
RODUCT
ANUAL
Page 25