Cleaning And Servicing; Safety Instructions - Project Food AKD200R Installation, Operating And Service Instructions

Defrosting - Defrost timing (see Pic.3 - Section 8)
In positive models (versions R, R SS and RG) the control unit automatically performs four defrost
cycles in a 24 hour period (once every 6 hours). When the defrost cycle is active, the "defrost" LED
on the control unit remains on. The defrost water evaporation is automatic.
The negative models (version F, F SS and FG) needs to be manually defrosted: proceed to manual
defrosting whenever the shelves are covered by a layer of 15 mm of ice or more. Proceed as
follow:

Transfer all the food in another freezer;

Turn off the appliance by disconnecting the power plug;

Leave the door open;

Wait until all of the ice has melted;

Dry the refrigerator with a soft cloth;

Reconnect the power plug and wait until the freezer have reached the set temperature
before putting back inside the food.
Precautions for use

To reduce cooling losses, do not open the door too often and keep it open as little as possible.

Do not cover the back of the appliance. The air must be able to circulate to properly cool the
compressor and also to evaporate the defrost water.

The food products must be placed at a sufficient distance from one another. Cooling is limited
if there is very little distance between products.

The height of the racks must be chosen based on the height of the food products.

If hot meals are to be stored, let them completely cool down before placing them inside the
appliance. Putting hot food or drinks inside the appliance creates an excessive amount of
steam which can cause anomalies and malfunctions.

In the event of a power failure, if possible, do not open the door to prevent cool air from
escaping.

Wait at least 10 seconds after disconnecting the plug before connecting the appliance to the
power supply line again.

6. Cleaning and servicing

6.1 Safety instructions


Disconnect the appliance from the mains electricity supply (remove the plug from the
socket) before cleaning the appliance or starting any servicing or repair activities.

Do not use aggressive detergent products and make sure that water does not enter the
control panel or inside the appliance's technician chamber.

To prevent electric shock, never clean the appliance with a jet of water, and never immerse
the appliance or its parts, the power supply cable or the plug in water or any other liquid.
WARNING! Risk of burns!
During normal use, the surface of the compressor can become very hot. Never
touch the compressor with your bare hands.
WARNING!
The appliance is not designed to be cleaned:



27
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
with a jet of water;
with a jet of high pressure water;
by immersing it or its parts in water or any other liquid.
- 27 -