Installation Of The Rfxtrxlan; Lan Version; Configure The Lan Controller - RFXCOM RFXtrxLAN Manual

5. Installation of the RFXtrxLAN

Connect the antenna.
Connect the 5V/1Amp DC power supply and the Ethernet cable.
The red LED of the RFXtrx should be on for about 3 seconds followed by a short blink of the
green/yellow LED. And the right LED on the Ethernet connector should blink and the left LED should
be on.
Note: Do not locate the RFXtrxLAN close to metal objects, electronic equipment or power lines.

6. LAN version

6.1. Configure the LAN controller

The RFXtrxLAN is delivered with DHCP.
To find the IP address of the RFXtrxLAN use for example the free NetScan tool
https://www.netscantools.com
Use a browser to configure the LAN-controller and enter the IP address of the RFXtrxLAN, for
example: http://192.168.1.237 or use the Host Name http://rfxtrxlan
Default Username / Password: admin admin
Set a fixed IP address for normal use. (select DHCP OFF) or configure the RFXtrxLAN in your router.
If multiple RFXtrxLAN devices are in use set the Host Name unique.
Advice: If you change the Username/Password write it down on a label inside the RFXtrxLAN
RFXtrxLAN Rev. 2.0 page 6 / 14
Copyright, RFXCOM 2021