Fig 2-10 Test Mode Operation Flow-Cha - Prodigit 33501 Series Operation Manual

S3+S4
Show n1-n9
Start Mode
Testing
Show Memery
bank and State
Yes
EXI
Press Exit key
End?
PASS
PASS/FAIL
4.2
Show GO
Any key
Initial = n1
1
Press Start key
1.To recall correspond memory which had been stored in n1-n9 memory
2.Check the GO/NG indicator
3.Press Exit key to quit the AUTU SEQ mode
4.If test is GO, than step is last?
2
3
Sp = Sp+1
No
4.1
4
No
Yes
FAI
4.3
Show NG

Fig 2-10 TEST MODE OPERATION FLOW-CHA

33501 Series Operation Manual 2-9
1.Press S3+S4 key, and S3 and S4 LED are ON
2.Show AUTO SEQ. No.1-No.9,
Press Up/Down key to set n1-n9
3.Press Start key to Start Mode
4.1 If no than Step + 1, continue another step.
4.2 If "Yes", than if all the test in all module is pass,
Show GO.
4.3 If "Yes", than if there is at least one failure during the test,
Show NG.