Receiver - Delta DE212 Installation And Operation Manual

8.3 Receiver

Antenna: 2,4GHz 5dBi gain, RP-SMA male connector. 20cm long
Antenna connector: RP-SMA connector on receiver top.
Power Supply: 11 to 27 V DC. Voltage above 35VDC shuts down the receiver.
Power Consumption: Standby: 50mA. During max charging: 100mA.
Connections: Screw terminal on PCB connectors.
Connections P1:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. INPUT, DP RESET/OVERRIDE. LOW INPUT IS ACTIVE
P2:
1.
2.
3.
4.
5.
P3:
1.
2.
3.
4.
5.
Output Signals.
All outputs are
12/24 V DC output when active. Receiver max load at all outputs: 5A
Input signals
Low inputs are active inputs: max 0,3VDC.
High input: min 4VDC, max 30VDC
Transmitter charging:
Charging is performed according to operating time of the transmitter.
Controls: CODE, push-button, for coding to the transmitter.
Indicators: ON, Green LED that indicates power on.
CH, Yellow LED that indicates recharging and in operation.
Housing: ABS polycarbonate, class IP52.
Dimensions: L:160 mm, W: 80 mm, D: 60 mm.
Weight: 0.3 kg
See also section: 3. for operational information.
D RC AS
ELTA
TIMER BEEPER OUTPUT
TIMER WARNING OUTPUT
HOSE REEL CONTROL OUTPUT
DEADMAN OUTPUT
STOP OUTPUT. NORMALLY HIGH, GOES LOW FOR STOP.
INTERLOCK OUTPUT
POWER INPUT, MINUS VOLTAGE, GND
POWER INPUT, PLUS+ 12/24V
OUTPUT F7, FOR FUTURE EXPANSION.
OUTPUT F8, FOR FUTURE EXPANSION.
OUTPUT F9, FOR FUTURE EXPANSION.
GND
DP OUTPUT
DP WARNING LIGHT OUTPUT
EXTERNAL OVERRIDE INPUT
DP SENSOR INPUT
EXTERNAL STOP INPUT
WIRED DEADMAN INPUT
GND
Semiconductor, High side drivers. 1A, each output.
.
Front panel charging station for transmitter, constant current 50mA.
Page 27 of 33
Document no: 03039