Changing The Function Of The Receiver Unit By Dip Sw3; Dp-Sensor Connection - Delta DE212 Installation And Operation Manual

2.10 Changing the function of the receiver unit by DIP SW3.

The function of the receiver unit can be changed according to operational requirements.
The following can be changed:
•
SW3-1: Timed or no timed Deadman. ON is activated.
With timer OFF, the deadman function will work as a normal ON-OFF switch with no time delay.
•
SW3-2: Simultaneous or no simultaneous operation of the extra function at the handheld
transmitter.
•
SW3-3: External override, enabled or disabled
•
-4: Differential Pressure Switch/ DP input at P3-2
SW3
•
-5: Wired Deadman input, P3-4. ON/OFF Deadman or Faisafe Delta Deadman
SW3
Default settings are shown
ON
To store the DIP SW3 settings in the receiver:
1.
Set the function switch, SW3 to the desired positions.
2.
Take out the fuse, F2 or switch OFF the power input.
3.
Press the yellow CODE-button on the receiver front and keep it pressed. Replace the fuse, or
switch ON the power of the receiver. Watch the green ON LED, keep the CODE-button pressed
until the green ON LED turns on. Normally the time for reading the new settings of the SW3,
takes about 3 secs.
When the ON is green, it indicates that the new settings of SW3 are successfully stored, and
the receiver is ready to operate.

2.11 DP-sensor connection

The receiver is prepared for connection of a DP-sensor, for Differential Pressure
protection. This sensor can be of different types.
For further information, see document 03073 or contact Delta RC,
D RC AS
ELTA
.
Standard factory settings of
SW3 Function
1 Deadman timer max 2min.
In OFF, instant operation, no
delays
2 Function 2:
OFF=Can not work
simultaneous with the
Deadman function
ON= Can work simultaneous
with the Deadman function
3 Deadman external override
4 DP sensor input
5 Wired deadman input
OFF=ON/OFF deadman switch
ON= Delta Failsafe wired
deadman
6 TBD
7 TBD
8 TBD
.
enabled or disabled
SW3
switches:
Comments
ON=Active Default
OFF= No timer
OFF=Default
For Hose reel operation.
ON: for pump speed
control
OFF= Default, not active
OFF= Default, not active
ON= DP sensor is read
OFF=Default
Optional
OFF= Default
OFF= Default
OFF= Default
hello@deltarc.no
Page 10 of 33
Document no: 03039