Hood Body Mounting; Chimney Assembly - Electrolux AEG DD9996-B Operating And Installation Instructions

Hood body mounting

• Firstly, it is necessary to adjust the two Vr-screws of
the 11a-brackets, at minimun (B).
• Hang the hood body on the two brackets 11a.
• Connect the hood to the mains supply by means of
a bipolar switch with at least 3 mm contact gap.
• see Part USE to open the upper panel
• Remove the metal filters by using the handles
• In order to align the hood it is necessary to adjust
the Vr-screws from inside the hood.
• Fasten the safety screw 11.
• Fit again the metal filters into their seats and see
Part USE to close the upper panel.
• Disconnect the hood from the mains supply.
Attention: If any barrier occurs in its way during the
panel opening or closing, the upper panel stops for
1 sec and starts again the other way round. If within
5 sec the panel does not open or close, the motor
stops. Press the key once again.

Chimney assembly

Upper exhaust Chimney
• Slightly widen the two sides of the upper chimney
and hook them behind the brackets 7.2.1, making
sure that they are well seated.
• Secure the sides to the brackets using the 4 screws
12c (2,9 x 9,5) supplied.
Lower exhaust Chimney
• Slightly widen the two sides of the chimney and
hook them between the upper chimney and the wall,
making sure that they are well seated.
• Fix the lower part laterally to the hood body using
the 2 screws 12c (2,9 x 9,5) supplied.
INSTALLATION INSTRUCTIONS
���
�
���
15
���
��
� � �
��
�����
���
���