Table of Contents
Advertisement
Wall drilling and bracket fixing
As a first step, proceed with the following drawings:
•
a vertical line up to the ceiling or up to the upper
limit, at the centre of the area in which the hood is to
be fitted;
•
a horizontal line at a minimum 960 mm above the
cooker top.
•
Mark a point (1) on the horizontal line, 292 mm to
the right of the vertical reference line.
•
Repeat this operation on the other side, checking
that the two marks are levelled.
•
Mark a reference point (2) as indicated at 200 mm
from the vertical reference line and 458 mm above
the cooker top.
•
Repeat this operation on the other side, checking
that the two marks are levelled.
•
Mark a reference point (3) at 743 mm above the
cooker top on the vertical reference line.
•
Drill at the marked points (1), using a ø 12 mm drill
bit.
•
Drill at the marked points (2) and (3), using a ø 8
mm drill bit.
•
Insert the bracket plugs 11a into the holes (1) and
tighten the screws.
•
Insert plug 11 into holes (2) and (3).
•
Place bracket 7.2.1 on the wall, about 1-2 mm from
the ceiling or from the upper limit, aligning the centre
(notch) with the vertical reference line.
•
Mark the wall at the centres of the bracket holes.
•
Place the bracket 7.2.1 on the wall at X mm below
the first bracket (X = height of the upper chimney
section), aligning the centre (notch) with the vertical
line.
•
Mark the wall at the centres of the bracket holes.
•
Drill ø 8 mm holes at all the marked centre points.
•
Insert the wall plugs 11 in the holes.
•
Fix the brackets using the 12a screws (4,2 x 44,4)
supplied with the hood.
INSTALLATION INSTRUCTIONS
���
��
���
��
���
14
�����
��� ���
�
�
�
���
���
�
�
���
Advertisement
Table of Contents
