Mounting The Hood Body; Ducted Version Air Exhaust System - Electrolux EFC 6510 Instruction Manual

• Before attaching the hood body, tighten the two
screws Vr located on the hood body mounting
points.
• Hook the hood body onto the screws 12a
• Fully tighten support screws 12a
• Adjust screws Vr to level the hood body.
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid
pipe ø 150 or 120 mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Remove any activated charcoal filters.
Lateral air exhaust on ducted version
(connection to exhaust flue above wall
cupboards)
• Assemble the half-shells of the hood body
extension piece 14.
• Push fit the assembled hood body extension 14
onto the air exhaust outlet.
• Insert the deflector 16 into the air exhaust fitting
15 to close off the unused outlet.
• Push fit connection piece 15 to the hood body
extension piece 14, ensuring that the free end
matches up with the opening of the required
outlet duct.
• Remove any activated charcoal filters.
GB

Mounting the hood body

Connections

DUCTED VERSION AIR EXHAUST SYSTEM

12a
15
16
Vr
14
15