Mounting The Hood Body; Ducted Version Air Exhaust System; Recirculation Version Air Outlet; Electrical Connection - Electrolux EFC 9500 Instruction Manual

Electrolux cooker hood

Hide thumbs

Table of Contents

• Before attaching the hood body, tighten the two

Vr Vr

screws Vr

Vr located on the hood body mounting

points.

• Hook the hood body onto the screws 12a

• Fully tighten support screws 12a

• Adjust screws Vr

Vr to level the hood body.

Vr Vr

When installing the ducted version, connect the hood to the chimney using either a flexible or rigid

pipe ø 150 or 120 mm, the choice of which is left to the installer.

• To install a ø 120 mm air exhaust connection,

insert the reducer flange 9 9 9 9 9 on the hood body

outlet.

• Fix the pipe in position using sufficient pipe

clamps (not supplied).

• Remove any activated charcoal filters.

• Put connection 15 15 15 15 15 into the connection support 7.3.

• Insert the connection extension pieces laterally 14.1

in connection 15.

15.

• Make sure that the outlet of the extension pieces 14.1

is horizontally and vertically aligned with the chimney

outlets.

• Connect the air outlet connection 15 15 15 15 15 to the hood body

outlet using either a flexible or rigid pipe ø 150 or

120 mm, the choice of which is left to the installer.

• Ensure that the activated charcoal filters have been

inserted.

• Connect the hood to the mains through a two-

pole switch having a contact gap of at least 3

mm.

• Remove the grease filters (see paragraph

Maintenance) being sure that the connector of

the feeding cable is correctly inserted in the

socket placed on the side of the fan.