Table of Contents
Advertisement
A second remote control can be purchased from your dealer to provide
dual remote control of one fan. Because the fan could be confused by
two controllers signaling different information it is necessary to set a
BASE control and an AUXILIARY control.
The last control manually operated controls the fan.
Where two remote controls are used to control a single fan, they must
be set so that:
• BOTH controls are set to the SAME channel.
• ONE control is made into the BASE control.
• The OTHER control is made an AUXILIARY control.
(All remote controls leave the factory as a BASE).
Initial remote control settings
1. Set both the controls to operate the fan.
2. Select one of the remote controls to be the BASE unit.
Change the other remote to be used in the room to AUXILIARY
1. Press
2. Press fan up
3. Press
The fan will now respond to either of the remotes when pressed.
• Reminder! These steps will have to be repeated whenever the
batteries are changed.
• When AUTO-SPEED, SECURITY, SAVER or TEST modes are in ef-
fect at any control: Automatic control will only be from the
control that was last operated manually.
When two controls are used for the same fan, we suggest that both controls be set for the same features
(AUTO-SPEED, SAVER, etc.) so that performance remains the same as you move from one to the other.
Remember, the fan will only respond to updates from the control that was last operated manually.
3. Press fan up
The control automatically changes the fanchannel to the new setting.Changing the contr
Do not reset the channel on other fans in
COMFORT•TOUCH
R
or down
CHANGING CHANNELS - CONTROL
COMFORT•TOUCH
COMFORT•TOUCH
until a beep is heard. Remote displays 'b'.
or down
buttons to change the display to 'A'.
again to set.
TWO CONTROLS OPERATING ONE FAN
COMFORT•TOUCH
vided on th
buttons to change the number to aunique number from 490to 63.DO NOT use other channel num
e rear label.
buttons tog
Note: Always change the remote control channel
first. The fan channel can only be changed by
having the desired channel already set in the re-
mote control.
DUAL REMOTE CONTROL - BASE
DUAL REMOTE CONTROL - AUXILIARY
ether until th
edisplay sh
ows 'cc' (f
or Change Chann
REMOTE
CONTROL
CHANNEL
NUMBER
BASE
DISPLAY
BASE Check
To confirm that the control is the BASE:
1. Press
for 3 seconds until a beep is
heard.
2. Confirm temperature display shows 'b'.
3. Press
again to set.
AUXILIARY
DISPLAY
ol channel1. Hold the button d
el), then r
elease.
17
own until
s
Advertisement
Table of Contents
