Regulatory Compliance Statements; Replacement Parts And Accessories; United States Of America - Gateway C-140 User Manual

Care during use
•
•
•

Replacement parts and accessories

Use only replacement parts and accessories recommended by Gateway.
Regulatory compliance
statements

United States of America

the FCC compliance and negate your authority to operate the port replicator.
Unintentional emitter per FCC Part 15
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio or television reception. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
interference to radio and television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
•
•
•
Compliance Accessories: The accessories associated with this port replicator are: shielded
video cable when an external monitor is connected. These accessories are required to be used in
order to ensure compliance with FCC rules.
www.gateway.com
Do not walk on the power cord or allow anything to rest on it.
Do not spill anything on the port replicator. The best way to avoid spills is to avoid eating
and drinking near your port replicator.
Unplug the port replicator from the wall outlet and refer servicing to qualified personnel
if:
•
The power cord or plug is damaged.
•
Liquid has been spilled into the port replicator.
•
The port replicator does not operate properly when the operating instructions are
followed.
•
The port replicator was dropped or the cabinet is damaged.
•
The port replicator performance changes.
Caution
Changes or modifications not expressly approved by Gateway could void
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
Consult the dealer or an experienced radio/TV technician for help.
9