Tripp Lite B127A-1A1-BHBH Owner's Manual page 34

Hide thumbs Also See for B127A-1A1-BHBH:

Transceiver Daisy-Chain Installation

(B127A-110-BH only)

10. Connect the external power supply to the B127A-110-BH

11. To add a second B127A-110-BH, repeat steps 8 through

12. Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the

13. Connect a monitor to the HDMI OUTPUT port on the

14. The green LED on the B127A-110-BH will illuminate to

15. Turn on the power to the HDMI source. The orange RJ45

-03-127-933CC9-EN.indd 34

Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the

B127A-111-BHTH receiver unit to the RJ45 INPUT port on

B127A-110-BH.

Connect a monitor to the HDMI OUTPUT port on the

B127A-110-BH that you just added using a Tripp Lite

P569-XXX-CERT or P568-XXX-2A Series HDMI Cable

and plug it into a Tripp Lite surge protector, power

distribution unit (PDU) or uninterruptible power supply

(UPS). The green power LED and the green RJ45 LEDs will

illuminate to indicate the unit is receiving power.

10. To finish your installation with a B127A-110-BH,

proceed to step 12.

last B127A-110-BH to the RJ45 INPUT port.

B127A-110-BH using a Tripp Lite P568-Series HDMI Cable.

indicate the unit is receiving power from the previous

transceiver. The orange LED will illuminate to indicate the

unit is connected to a powered ON remote/repeater unit.

LEDs on the local unit will illuminate to indicate a signal is

being received from the source.

3/24/2021 9:38:16 AM