Tripp Lite B127A-1A1-BHBH Owner's Manual page 31

Hide thumbs Also See for B127A-1A1-BHBH:

Standard Extender Kit Installation

10. The orange RJ45 LED will illuminate on both the local

Transceiver Daisy-Chain Installation

(B127A-110-BH only)

Notes:

•

Test to ensure the entire installation works properly before pulling

cables through ceilings/walls.

•

To achieve maximum distance and performance, use 24 AWG solid

wire Cat5e/6 cable. Using stranded wire Cat5e/6 cable or cable with a

gauge (AWG) size higher than 24 AWG will result in shorter extension

distance. Higher-gauge cabling, such as 26 AWG, has a more limited

transmission capability than lower-gauge cabling. All Tripp Lite

N202-Series Cat6 cables are made with 24 AWG solid wire cabling.

•

The installation diagram shows the B127A-111-BHTH and

B127A-110-BH installation.

-03-127-933CC9-EN.indd 31

Connect the external power supply to the transmitter. Plug

it into an available wall outlet or a Tripp Lite surge protector,

power distribution or uninterruptible power supply (UPS).

The POWER (green) LED on the local transmitter unit will

illuminate to indicate the unit is receiving power from the

external power supply. The POWER (green) LED on the

remote receiver unit will illuminate to indicate the unit is

receiving power from the local transmitter unit through

PoC technology.

Turn on the power to the HDMI source.

transmitter and remote receiver units to indicate a signal is

being received from the source to display. The screen should

now display on the connected monitor.

3/24/2021 9:38:16 AM