Advertisement
Transceiver Daisy-Chain Installation
(B127A-110-BH only)
1.
2.
3.
4.
5.
6.
7.
-03-127-933CC9-EN.indd 33
-03-127-933CC9-EN.indd 33
Make sure all equipment in the installation—such as TVs,
Blu-ray players and the transmitter—is powered OFF.
Connect the HDMI source to the INPUT port on the
B127A-111-BHTH using a Tripp Lite P569-XXX-CERT or
P568-XXX-2A Series HDMI Cable.
Connect a local monitor to the LOCAL HDMI port using
a Tripp Lite P569-XXX-CERT or P568-XXX-2A Series
HDMI Cable.
Connect the external power supply to the local unit and plug
it into a Tripp Lite surge protector, power distribution unit
(PDU) or uninterruptible power supply (UPS). The green RJ45
LEDs will illuminate to indicate power is being received from
the external power supply.
Using Cat5e/6 cable, connect one of the RJ45 output ports
on the local unit to the RJ45 input port on the
B127A-110-BH transceiver unit.
Connect a monitor to the HDMI OUTPUT port on the
transceiver unit using a Tripp Lite P569-XXX-CERT or
P568-XXX-2A Series HDMI Cable.
The green power LED and the green RJ45 LEDs on the
transceiver will illuminate to indicate the unit is receiving
power. Up to four units can be daisy-chained (three
transceivers and one receiver). To connect additional
transceiver units, proceed to step 8. To finish your
installation with a B127A-110-BH unit, proceed to step 12.
33
3/24/2021 9:38:16 AM
3/24/2021 9:38:16 AM
Advertisement
