Sharp SF-A57 Service Manual page 4

3. Adjust the angle of ADF.
Loosen the two securing screws for the angle adjusting panel at-
tached to the hinge angle and then fasten the loosened screws while
raising the angle adjusting panel completely.
Angle adjusting panel
securing screws
Long hole
Hinge
Angle adjusting panel
NOTE:
Be sure to check that the protrusion of the angle adjusting panel
is securely inserted into the long hole of the hinge.
4. Connect the ADF connector.
Remove the connector cover from the copier's rear cover.
Next, connect the ADF connector to the connector on the copier.
ADF connector
Long hole
Connector on the copier
Connector cover
5. Connect the ADF tray connector.
Thread the M4 x 8 tray securing screws (included parts) partway into
their holes, then connect the tray connector.
Tray
securing
screws
6. Attach the ADF tray.
Loosen the two ADF tray securing screws, install the tray as shown in
the figure, and fasten the tray securing screws.
Tray
securing
screws
Plug the copier into a grounded outlet and turn the
power switch on. Then, follow the procedure below.
7. Set the mode.
•
Operate the copier keys to set the mode.
C
5
The above key operation will display the currently set mode.
•
When only the SF-A56 is to be set, immediately after the above
key operation, operate the keys as follows:
0
//
– 3 –
Tray connector
Connector on the ADF
Tray
//
0
//
1