Transportation; Storage; Care And Maintenance; Troubleshooting Guide - Kärcher CVH 2 Manual

Transportation

The battery has been tested in accordance
with the relevant rules for international
transport and can be transported / shipped.

Storage

Note
● Store the appliance in a dry room.
● Consider the weight of the appliance
when storing it.
1. Insert the appliance into the storage
dock.
2. Put the crevice nozzle and the upholster
brush into accessory storage.

Care and maintenance

Note
● Use the appliance only when all filters
and the dust container are installed.
● Defective filters and filters that can no
longer be cleaned must be replaced.
Before doing any work on the appliance:
1. Switch off the appliance.
2. Unplug the power supply from the power
outlet.
Cleaning the filter set and the dust
container
ATTENTION
Incorrect cleaning of the HEPA filter
Damage to the HEPA filter
Do not wash the HEPA filter.
Do not clean the HEPA filter in a washing
machine.
Malfunctions often have simple causes that you can remedy yourself using the following
overview. When in doubt, or in the case of malfunctions not mentioned here, please contact
your authorised Customer Service.
Fault
The appliance does
not run.

Troubleshooting guide

Possible cause
Battery is nearly empty.
The appliance is in danger of
overheating.
Do not dry the HEPA filter with a hair dryer.
The HEPA filter ensures clean exhaust air.
● Clean the HEPA filter if it is visibly dirty.
● Replace the HEPA filter if it is visibly
damaged.
● We recommend replacing the HEPA fil-
ter every 6 months based on your use of
the device.
1. Unlock the dust container.
Illustration G
2. Unplug the filter set from the dust con-
tainer. Turn the filter cover counterclock-
wise. Remove the filter cover, unplug the
HEPA filter from the steel filter.
Illustration H
3. Clean the HEPA filter, and carefully
empty / knock the dirt out of the HEPA fil-
ter.
Illustration I
4. Empty the dust container, and rub down
inside using a cloth.
Illustration J
5. Clean the filter cover, steel filter and dust
container under running water.
Illustration K
6. Allow the filter cover, steel filter and dust
container to dry completely.
Illustration L
7. Insert the filter set into the dust contain-
er, and turn the dust container clockwise
to latch into place.
Illustration M
Remedy
1. Charge the battery.
1. Check whether the dust contain-
er is clogged.
2. Clean the dust container.
3. Switch the appliance on again.
English 11