Table of Contents
Advertisement
The following screen appears if you select any of the IDE Drive
parameters:
IDE Primary/Secondary
Channel Master/Slave
Type...........................[ Auto ]
Cylinder.....................[ XXXX ]
Head.........................[ XXXX ]
Sector.......................[ XXXX ]
Size.........................[ XXXX ] MB
Hard Disk Size > 504MB.........[ Auto ]
*Hard Disk Block Mode...........[ Auto ]
*Advanced PIO Mode..............[ Auto ]
*Hard Disk 32-Bit Access........[Enabled ]
*DMA Transfer Mode..............[ Auto ]
*CD-ROM Drive DMA Mode..........[Disabled]
¯ = Move Highlight Bar, ¬ ® = Change Setting, F1 = Help
The above parameters marked with '*' will
only appear if you access the advanced
configuration level in the Main Menu. Please
refer to section 2.1.1 for more information.
This parameter lets you specify the type of hard disk installed in your
system. If you want BIOS to automatically configure your hard disk,
select
Auto
.
If you know your hard disk type, you can enter the
setting manually.
Setting this parameter also sets the Cylinder, Head, Sector, and Size
parameters.
BIOS Utility
TYPE
Page 1/1
2-15
Advertisement
Table of Contents
