Download Print this page
Acer V70MA Safety Instructions

Acer V70MA Safety Instructions

Acer v70ma motherboards: user guide
Hide thumbs Also See for V70MA:

Advertisement

Quick Links

User's Guide

Advertisement

loading

Summary of Contents for Acer V70MA

  • Page 1 User’s Guide...
  • Page 2 Copyright 1998 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company.
  • Page 3 Read these instructions carefully. future reference. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. Do not use this product near water. Do not place this product on an unstable cart, stand, or table.
  • Page 4 Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord. 10. If an extension cord is used with this product, make sure that the total ampere rating of the equipment plugged into the extension cord does not exceed the extension cord ampere rating.
  • Page 5 14. Replace the battery with the same type as the product's battery we recommend. Use of another battery may present a risk of fire or explosion. Refer battery replacement to a qualified serviceman. 15. Warning! The battery may explode if not handled properly. Do not recharge, disassemble, or dispose of it in fire.
  • Page 6 DANGER INVISIBLE RADIATION WHEN OPEN. AVOID EXPOSURE TO BEAM. VORSICHT UNSICHTBARE LASERSTRAHLUNG WENN GEÖFFNET. NICHT IN DEN STRAHL SEHEN. ATTENTION RADIATION DU FAISCEAU LASER INVISIBLE. EN CAS D’OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYONS. VARO AVATTAESSA OLET ALTTIINA NÄKYMÄTTÖMÄLLE LASERSÄTEILYLLE ÄLÄ KATSO SÄTEESEEN. VARNING! OSYNLING LASERSTRÄLNING NÄR DENNA DEL ÄR ÖPPNAD.
  • Page 7 CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions. ADVARSEL! Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Léver det brugte batteri tilbage til leverandøren.
  • Page 8 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 9 Purpose This user’s guide aims to give you all the necessary information about the system board, such as system board layout, onboard components, jumper settings, cache and memory configurations, and other internal devices. Conventions The following are the conventions used in this manual: NOTE Gives bits and pieces of additional information related to the current...
  • Page 10 Major Components...2 System Board Layout...4 Jumpers and Connectors...5 Jumper and Connector Locations...5 Jumper Settings...6 Onboard Connector Functions...8 Installation Precautions ...9 ESD Precautions...9 Pre-installation Instructions...9 Post-installation Instructions ...10 Memory Configurations...11 Installing a DIMM ...11 Removing a DIMM ...12 Reconfiguring the System...13 Second-level Cache...14 Upgrading the CPU...14 Removing the CPU ...14...
  • Page 11 Hardware Monitoring Function...24 Wake-on Ring-in Function...24 Wake-on LAN Function ...25 Error Messages ...25 17.1 Software Error Messages ...25 17.2 System Error Messages ...25 17.3 Correcting Error Conditions ...28 List of Figures System Board Layout...4 System Board Jumper and Connector Locations ...5 Installing a DIMM ...12 Removing a DIMM ...13 Removing the CPU ...15...
  • Page 12 List of Tables Jumper Settings ...6 System Board Connectors ...8 Memory Configurations ...11 Second-level Cache Configurations ...14 IDE Hard Disk Configuration ...17 Supported Video Resolutions...18 System Error Messages...26...