Garmin Apollo GX 50 User Manual page 257

1. Point A - At 30 nm west of the MFR airport, you
will be prompted to "Enable Approach." As the
current Track Angle is less than 70° to the
FAF-MAP leg, sequencing is not suspended.
2. As you cross over the OED VOR (IAF) at point E,
the unit will sequence to MA14, because
sequencing was not suspended prior to OED.
3. If you still need to fly the procedure turn to lose
D D
altitude, set the OBS course for the inbound course.
Press
the
select OED (IFAF) as the reference waypoint.
ENTER
Verify that waypoint sequencing is set to "auto."
Press
that your CDI will "reverse-sense" while outbound,
just like a VOR with 153°-TO selected on the OBS.
Also, the TO/FROM flag will change to TO.
3. Point C, shows the procedure turn.
4. At point D, you will receive a course intercept alert.
Sequencing will be automatically enabled. OED
becomes the FAF and the Apollo GX will
transition to Approach Active at OED.
5. At point E, the Apollo GX will be in Approach
Active operation.
twice to reach the OBS page. Use
DIRECT-TO
and
SMALL LARGE
to establish an inbound course. Note
ENTER
Approach Examples
knobs to select 153° and
9-67