Table of Contents
Advertisement
en PowerManager function
19.2 Checking the result
In the following table, you can check the result for the
quality and speed of the cooking process:
Result
The cookware is not suitable for the
cooking zone and therefore does not
heat up.
If a smaller cooking zone is available, test the cook-
1
ware on this cooking zone.
20 PowerManager function
You can use the PowerManager function to configure
the total power of the hob.
The hob settings are preconfigured at the factory. You
can use this function to configure the settings in ac-
cordance with the requirements of an electrical installa-
tion.
In order to not exceed this set value, the hob automat-
ically distributes the available power as needed
between the cooking zones that are switched on.
21 Basic operation
21.1 Switching on the appliance
Turn the function selector to any position other than
▶
the "Off" position .
a The appliance is switched on.
21.2 Switching off the appliance
Turn the function selector to the "Off" position .
▶
a The appliance is switched off.
21.3 Types of heating and temperature
Use the function selector to set the type of heating.
1.
Use the temperature selector to set the temperature
2.
or grill setting.
a The appliance starts heating after a few seconds.
22 Rapid heating
To save time, you can use the rapid heating to shorten
the preheat time.
Only use rapid heat-up when a temperature of over
100 °C has been set.
After rapid heating, it is best to use the following types
of heating:
¡ 3D hot air
¡ Top/bottom heating
24
1
Result
The cookware is taking longer to heat
up than expected and cooking is not
progressing as well as it ought to.
The cookware is heating up correctly
and cooking is progressing well.
1
If a smaller cooking zone is available, test the cook-
ware on this cooking zone.
To activate this function, touch the settings range.
While the PowerManager function is activated, the out-
put of a cooking zone may temporarily fall below the
nominal value. In order to not exceed this set value, the
hob automatically distributes the available power as
needed between the cooking zones that are switched
on . The appliance regulates and selects the highest
power level automatically.
If the automatic power limitation is activated, the appli-
ance self-regulates but continues to display the selec-
ted power level unchanged.
For more information, go to .
3.
When the dish is ready, switch off the appliance.
Tips
¡ The most suitable type of heating for your food can
be found in the description of the types of heating.
¡ You can also set a cooking time and an end time
on the appliance.
→ "Time-setting options", Page 25
Changing the type of heating
You can change the type of heating at any time.
Use the function selector to set the required type of
▶
heating.
Changing the temperature
You can change the temperature at any time.
Turn the temperature selector to set the desired
▶
temperature.
22.1 Setting rapid heating
To ensure an even cooking result, do not place the
food in the cooking compartment until rapid heating
has come to an end.
Use the function selector to select rapid heating .
1.
Use the temperature selector to set the required
2.
temperature.
a Rapid heating starts after a few seconds.
a When the rapid heating process ends, an audible
signal sounds and the heating indicator goes out.
1
Advertisement
Table of Contents
