Table of Contents
Advertisement
en Individual safety switch-off
16 Individual safety switch-off
If you operate a cooking zone for an extended period
and do not change any settings, the automatic safety
shut-off is activated. Depending on which performance
level has been selected, the cooking zone switches off
automatically after 1 to 10 hours.
This stops the cooking zone from heating up. and
the residual heat indicator or flash alternately in the
cooking zone display.
17 Basic settings
You can configure the appliance to meet your needs.
17.1 Overview of the basic settings
Display
Function
Childproof lock
1
Manual.
Automatic.
Function deactivated.
Audible signals
Confirmation and fault signals are deac-
tivated.
Only the fault signal activated.
Only the confirmation signal is activated.
All signal tones are activated.
Display energy consumption
Deactivated.
Activated.
Automatic switch-off of the cooking
zones
Switched off.
- Time until automatic switch-off.
Duration of the timer end signal tone
10 seconds.
30 seconds.
1 minute.
The power limitation function limits the
total power of the hob
. The available settings depend on the
maximum power of the hob.
Deactivated. The hob's total power out-
put is limited.
1000 W minimum power
. 1500 W
...
3000 W is recommended for 13 A.
. 3500 W is recommended for 16 A.
4000 W
. 4500 W is recommended for 20 A.
...
or . The hob's total power output is lim-
ited.
Time for selecting the cooking zone
Unlimited: The cooking zone that was
last set remains selected.
Limited: The cooking zone only remains
selected for a few seconds.
Factory setting
1
22
1
1
1
1
1
1
To switch off the display, touch any symbol. You can
set the cooking zone again.
Display
Function
Cookware test, result
Not suitable.
Not optimal.
Suitable.
Automatic management with power limit-
ation
Deactivated: Shows the power limitation
according to the power management
1
function.
Activated: Does not show the power limit-
ation of the power management function.
Restoring factory settings
Individual settings.
Factory settings.
1
Factory setting
17.2 To go to the basic settings
Requirement: The hob must be switched off.
To switch on the hob, touch
1.
Within the next 10 seconds, touch and hold
2.
four seconds.
Product information
Directory for the technical after-sales
service (TK)
Production number
Production number 1
Production number 2
a The first four displays provide the product informa-
tion. To call up the individual displays, touch the
control panel.
1
.
for
Display
.
.
Advertisement
Table of Contents
