Table of Contents
Advertisement
Touch
to access the basic settings.
3.
a
and , along with , light up alternately as a pre-
setting.
Touch
repeatedly until the required function is dis-
4.
played.
18 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
19 Checking the cookware
You can use this function to check the speed and qual-
ity of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the cooking zone being
used.
You can find more information about this function un-
der
→ "Basic settings", Page 22 and on the type, size and
positioning of the cookware under
→ "Induction cooking", Page 8.
19.1 Procedure for checking the cookware
Fill the cookware with approximately 200 ml water
1.
and place it at room temperature in the middle of
the cooking zone that most closely matches the dia-
meter of the base of the cookware.
Call up the basic settings and select .
2.
Touch the control panel. The
3.
the cooking zones.
a The function has now been activated.
a After 20 seconds, the result appears in the cooking
zone displays.
display flashes in
Energy consumption display en
Select the required setting in the settings range.
5.
Touch and hold
for four seconds.
6.
a The settings are saved.
17.3 Exiting the basic settings
Touch
to switch off the hob.
▶
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
→ Page 22
Note: If the diameter of the cooking zone that is used
is much smaller than the diameter of the cookware,
only the middle of the cookware can be expected to
heat up. This may result in the cooking results not be-
ing as good as expected or being less than satisfact-
ory.
23
Advertisement
Table of Contents
