Advertisement
Demonstration Preparation
All demonstrations use an X-Series
signal analyzer with the phase noise
measurement application and the
N5181A MXG analog signal generator
(unless otherwise noted). Keystrokes
surrounded by [ ] indicate front-panel
keys; keystrokes surrounded by
{ } indicate softkeys located on the
display.
Demonstration Setup
Connect the X-Series and MXG
Perform the following steps to
interconnect the X-Series and MXG
(see Figure 1 for a graphical overview):
A. Connect the MXG RF output port
to the X-Series RF input port with
a 50 Ω RF cable
B. Connect the MXG "REF IN" to the
X-Series "10 MHz OUT" port (rear
panel) with a BNC cable
Minimum equipment configuration requirements
Product type
Model number
MXG (or PSG,
N5181A or any other
ESG) analog or
signal generator with CW
vector signal
RF signal output
generator
N9030A PXA, N9020A
X-Series signal
MXA, N9010A EXA, or
analyzer
N9000A CXA
Phase noise
N9068A (PXA, MXA, EXA)
measurement
W9068A (CXA)
application
Helpful tip:
Update your instrument firmware and software
to the latest version, available at
www.keysight.com/find/xseries_software
www.keysight.com/find/signalstudio
Figure 1. Demonstration setup
2
Required options
– Option 503 or any other frequency option
– Option 503 or any other frequency option
– Option 2FP – fixed perpetual license
– Option 2TP – transportable perpetual
license (not available for CXA)
10 MHz
OUT
REF IN
Advertisement
