Ecomiser SU-01 Manual page 14

3-4 Cycle LED
Will display during cycle. (Washing, Detergent, Rising, Rinse Agent, Finish)
1) Washing
- If the door is opened then closed, wash cycle will begin within 2 seconds
- While the door is closed, press START/STOP button to initiate the wash cycle.
- While READY LED is turned off, machine will not operate.
- After each cycle is completed, it will move in sequence.
- If FLOAT SWITCH is turned off before the washing cycle begins, LED will not work.
2) Detergent
- At programmed time, detergent will be supplied.
3) Waiting
- After the wash cycle, machine will be put into waiting mode
- Machine will stop for previously set time
4) Rinsing
- Rinse cycle is in operation.
- After programmed time, rinse cycle will end.
5) Rinse Agent
- At programmed time, rinse agent will be supplied.
6) Finish
- When the rinse cycle is finished, the WHOLE CYCLE is finished.
- FINISH LED will light up.
- End message will appear.
- After the end buzzer sounds (3 Times), for 30 seconds on the DISPLAY, the END
message will appear
3-5 Temperature Display – ℃ or ℉ (Celsius or Fahrenheit)
- After 30 seconds machine will reset to the beginning
4. Power
4-1 POWER Button
1) Turns the power ON.
2) While the power is turned OFF, everything is stopped.
3) While ERROR message is displayed, press the power button to clear the message.
4-2 START/STOP Button
1) Button is used to start and/or stop the whole cycle.
2) If cycle is interrupted by opening the door, the message PAU will be displayed.
Immediately press the START/STOP button to cancel message when the door is closed.
3) START/STOP button will stop any ongoing cycle.
4) START/STOP button will manually stop the DRAIN CYCLE after the power is turned off.
4-3 START/STOP Button
(Press and hold the button for 7 seconds to initiate MODE) If there is no activity for more than
3 seconds, you will exit the MODE function.
1) Press MODE button 1 time
2) Press MODE button 2 times Configure DETERGENT cycle duration
3) Press MODE button 3 times Configure WAIT MODE
4) Press MODE button 4 times Configure RINSE cycle duration
5) Press MODE button 5 times Configure RINSE AGENT cycle duration
6) Press MODE button 6 times Configure HIGH temperature
9) Press MODE button 9 times Switches temperature display between ℃ & ℉
7) Press MODE button 7 times Configure LOW temperature
8) Press MODE button 8 times Configure BUZZER on/off setting
10) Press MODE button 10 times Displays DRAIN cycle duration (DIP Switch UC only)
11) Press MODE button 11 times Displays Model Number
12) Press MODE button 12 times Returns to beginning
Ecomiser SU-01 / SU-02 Manual – Rev. 06
Configure WASH cycle duration
Page 14 of 23