Ecomiser SU-01 Manual page 11

NOTE
- No portion of a wall drain system may be higher than 18" (457mm).
- No part of the drain hose should be higher than 20" (508mm) from the bottom of the dishwasher.
- Failure to provide the proper drain connection height (maximum of 20" (508mm)) above the
bottom of the dishwasher base) will result in improper drainage.
- After connecting the drain hose to main drain line, make sure all connections are watertight
4. DISPENSING SYSTEM CONNECTION
The Ecomiser SU-01 / SU-02 models are designed for use with a liquid rinse aid and detergent. The
Ecomiser SU-01 / SU-02 models equipped with liquid internal detergent and rinse aid pumps each
have each tube exiting the machine at the lower rear. These tubes can simply be attached to detergent
and rinse aid containers.
- Commercial (not a domestic) detergent must be used.
- Locate the red liquid detergent and blue liquid rinse aid tube at the lower rear of the machine.
Connect the tubes to the detergent and rinse aid container.
Figure 1-4 Liquid rinse & detergent injection
This figure shows you how tubes are to be connected to detergent /
rinse containers.
a) Make a hole about 3mm bigger than the tube diameter on the
container cap (No. 1)
b) Insert the tube through the container cap into the sinker cap (No. 2)
c) Tighten the sinker cap on to the sinker (No. 3)
d) Drop the sinker down to the bottom of the container to supply
chemical properly.
5. DETERGENT & RINSE AGENT SETTING
This mode will only work if the READY LED light is on.
1) Detergent - While the power is turned on, press MODE and UP button simultaneously to supply
detergent.
2) Rinse Agent – While the power is turned on, press MODE and DOWN button simultaneously to
supply rinse agent.
Ecomiser SU-01 / SU-02 Manual – Rev. 06 Page 11 of 23