Permobil Corpus Owner's Manual page 23

Owner's Manual Corpus
Design and function
Memory Function
ICS Control Panels equipped with Memory can store and recall
up to three seat positions. A seat function (e.g. power tilt, power
recline, power legs, etc.) can only remember a saved memory
position if it has an actuator with position feedback installed.
Storing memory
Before storing a seating position in memory, position the seating system in the
position that is desired to be stored.
- Enter the memory mode by pressing and holding the memory button (8) for two
seconds, see illustration below. While in the memory mode, the LED flashes green.
- Press and hold button (4) until the LED immediately to the left of the Memory
LED lights green. You have now "enabled" storing and are ready to store a
memory seat position.
- Press and hold the desired "store" button (5, 6 or 7) for three seconds to mem-
orize the current seat position in a memory location, see illustration below.
- The LED above the memory position will light red and the control panel will
emit a tone when the memory has been successfully stored.
- Return to standard seat function operating mode by pressing the memory but-
ton (8), see illustration below.
Recalling memory
- Enter the memory mode by pressing and holding the memory button (8) for
two seconds, see illustration below. While in the memory mode, the memory
LED flashes green.
- Press and hold the desired "recall" button
(1, 2 or 3) to move the seating system to
the desired memory position, see illustra-
tion. Releasing the "Recall" button stops
actuator movement, as a safety feature.
- Actuator movement stops, the LED
above the memory position lights green
and the control panel emits a tone, when
the "stored" position is reached.
- Return to standard seat function operat-
ing mode by pressing the memory button
(8), see illustration.
1
5
Memory functions.
23
Design and Function
2
3
4
6
7
8