Table of Contents
Advertisement
7.1 Ambulance Information
The transporter is for use with ambulances that meet the Type II
requirements of the Federal Ambulance Specification KKK-A-1822.
The patient compartment must have:
a smooth edge on the floor at the rear door
●
a level floor large enough for the folded transporter
●
●
space to install the safety hook (below)
●
a compatible Ferno fastening system installed (not supplied)
If necessary, modify the ambulance to fit the transporter. Do not modify
the transporter or its operating procedures.
7.2 Placing Equipment on the Panel
The panels are designed to hold equipment required for use with a
transport incubator. The slots in the panel allow restraint straps to be
attached to secure equipment.
Plan the placement of the equipment before using the transporter with
an infant. Have your bio-med technician (or the controlling EMS) direct
the placement and securing of the equipment on the panels.
Confirm that equipment placed on the panels
●
Is secured to the panel.
Does not interfere with transporter operation.
●
Does not unbalance the transporter.
●
7.3 Accessories
Have your service technician or EMSAR
with the transporter. Follow the instructions included in the accessory
packages. Save the instructions with this manual for future reference.
7.4 Safety Hook Installation
The safety hook (provided, Figure 18) secures the transporter inside
the ambulance during the loading and unloading process while the
operators extend or retract the legs.
A correctly-positioned safety hook allows the transporter to be loaded
into the ambulance and unloaded from the ambulance without
interference, but will catch the safety bars during every loading and
unloading sequence.
Refer to document 234-3782 for placement and installation of the
safety hook.
20
Model 35-ITA Incubator Transporter
7 - SETUP
attach any accessories shipped
®
WARNING
Attaching improper items to the transporter can cause
injury. Use only Ferno-approved items on the transporter.
Equipment improperly placed on the panels can cause
injury. Consult a bio-med technician, the controlling EMS,
or Ferno for direction on equipment placement.
Failure to use the safety hook can cause injury. Install and
use the safety hook as described in this manual.
Improper installation can cause injury. Install the safety
hook so the safety bar catches the hook during every
loading and unloading sequence.
Modifying the transporter can cause injury and damage.
Use the transporter only as designed by Ferno.
NOTICE
Loose items and debris on the patient compartment floor
can interfere with the operation of the transporter with the
fastening system. Keep the patient compartment floor clear.
© Ferno / 234-1929-06 / July 2021
18
Advertisement
Table of Contents
