Table of Contents
Advertisement
5.4
Installation using clamp
fixing-bars
The clamp fixing-bars are used when attaching the UNI-ClipDoc to Ferno PowerX or iNX trolleys. The clamp
fixing-bars have three different configurations. The correct configurations required for installation on the
various trolleys are shown below.
When installing on the PowerX trolley, the clip-on spacer marked "PowerX" should be installed on both the
head-end and foot-end fixing-bars.
To install the clip-on spacers, align the three pegs with the sockets and push down into place.
To remove the clip-on spacers, simply pull up to release the three pegs from the sockets.
When installing on an INX trolley, remove all clip-on spacers from one fixing-bar and install at the foot-end.
For the head-end fixing bar, remove the PowerX spacer and install the clip-on spacer marked INX head-end
and position this bar at the head-end of the trolley.
FERNO/MAN/0721/220-R2/UK
5.0 - OPERATION
UNI-ClipDoc
11
Advertisement
Table of Contents
