Inspecting The Trolley And Uni-Clipdoc - Ferno UNI-ClipDoc Manual

Maintenance
7.6 - Inspecting the Trolley and UNI-ClipDoc before use
To ensure consistently safe operation of the trolley and UNI-ClipDoc interface and to monitor wear and tear, prior to each use, ensure the
trolley is thoroughly checked in compliance with the following checklist.
INSPECTION CHECKLIST
Are all components present?
●
Is the trolley and UNI-ClipDoc generally free of excessive wear?
●
Are all screws, nuts, bolts and rivets securely in place?
●
● Do all moving parts operate smoothly and properly?
● Does the trolley raise and lower properly into position with UNI-ClipDoc attached?
● Does the trolley move
Do the wheel castors and brake operate properly, rotate fully and have adequate tread?
●
For powered trolleys check that the battery is fitted to the trolley and that it is fully charged
●
at the beginning of each shift
Press the button located on the battery and check the red LED's light up test the battery and ensure it is ready to use.
●
Confirm the operation of the trolley by using the up/down control buttons on the foot-end main frame.
●
Check that the trolley cotsides raise, lower and lock in
●
● Check that the ambulance has a properly installed, approved locking device and that the trolley locks in
● Check the operation of the push/pull handles and push poles
18
7 - MAINTENANCE
________________________________________________________________________
smoothly?____________________________________________________________________
______________________________________________________________________
____________________________________________
___________________________________________________
____________________________________________________
position.____________________________________________
_____________________________________________
___________________________
_______________________
__________
securely.__
FERNO/MAN/0721/220-R2/UK
TICK