Select And Start A Washing Program - Electrolux ESL 66010 User Manual

12 electrolux
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents.
Do a check if these tablets are suitable for the
local water hardness. Refer to the instruc-
tions from the manufacturer.
The multitab function can be set with any
program.
When you set the multitab function, it stays
on until you deactivate it.
The multitab function automatically stops the
rinse aid and water softener operation. The
rinse aid indicator light and salt indicator light
are deactivated.
The program duration can increase if you use
the multitab function.
Activate or deactivate the multitab func-
tion before the start of a washing pro-
gram.
You cannot activate or deactivate the
multitab function when the program op-
erates. Cancel the washing program,
then set the program again.
To activate the multitab function:
• Press and hold the two multitab buttons
(function buttons D and E). The multitab
indicator light comes on.
To deactivate the multitab function:
• Press and hold the two multitab buttons
(function buttons D and E). The multitab
indicator light goes off.
Follow these steps if the drying re-
sults are not satisfactory:
1. Fill the rinse aid dispenser with rinse
aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.

Select and start a washing program

Set the washing program with the door
ajar. The washing program only starts
after you close the door. Until then it is
possible to modify the settings.
Follow these steps to set and start a washing
program:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
• You can only activate or deactivate
the rinse aid dispenser when the mul-
titab function is activated.
To activate/deactivate the rinse aid
dispenser:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons
A, B, and C start to flash.
4. Press function button B.
– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
– The digital display shows the setting.
5. Press function button B again.
– The digital display shows the new set-
ting.
6. Switch off the appliance to save the op-
eration.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing program without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
3. Press one of the program buttons. Refer
to the 'Washing programs' chart for pro-
gram details.
– The indicator light of the selected pro-
gram stays on. All other program indi-
cator lights go off.
– The digital display shows the program
duration.
4. Close the door.
– The washing program starts.
Rinse aid dispenser de-
activated
Rinse aid dispenser ac-
tivated