Electrolux ESL 66010 User Manual page 13

When the washing program operates,
you cannot change the program. Cancel
the washing program. Refer to 'Cancel-
ling a washing program'.
Select and start a washing program with
delay start
1. Press the on/off button.
2. Set a washing program.
– The program indicator light comes on.
3. Press the delay start button until the dis-
play shows the necessary delay start of
the washing program.
– The delay start indicator light comes
on.
4. Close the door.
– The countdown of the delay start
starts.
– When the countdown is completed,
the washing program starts automati-
cally.
If you open the door during the count-
down, it will interrupt the countdown.
When you close the door again, the
countdown continues from the point of
interruption.
Cancelling a delay start
1. Press and hold function buttons B and C
until all the program lights come on.
– When you cancel a delay start, you also
cancel the washing program.
2. Set a new washing program.
Warning! Only interrupt or cancel a
washing program if necessary.
Attention! Open the door carefully.
Hot steam and water can escape.
Interrupting a washing program
Open the door.
• The program stops.
Close the door.
• The program continues from the point of
interruption.
Cancelling a washing program
1. Press and hold function buttons B and C
until all the program lights come on.
2. Release function buttons B and C to can-
cel the washing program.
At this point, you can follow these steps:
1. Switch off the appliance.
2. Set a new washing program.
Fill the detergent dispenser with detergent
before you set a new washing program.
End of the washing program
The washing program is complete when:
• The appliance stops automatically.
• The audible signal for the end of the pro-
gram operates.
1. Open the door.
– The digital display shows 0.
– The indicator light for the completed
program stays on.
2. Switch off the appliance.
– For better drying results, keep the door
ajar for some minutes before you re-
move the dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are
easily damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
• There can be water on the sides and door
of the appliance. Stainless steel becomes
cool more quickly than the dishes.
Standby mode
If you do not switch off the appliance at the
end of the washing program, the appliance
automatically goes into standby mode. The
standby mode decreases power consump-
tion to less than 1 watt.
Three minutes after the end of the program,
all indicator lights go off and the digital display
shows one horizontal bar.
Press one of the buttons (not the on/off but-
ton), to go back to end-of-program mode.
electrolux 13