Select And Start A Washing Program - Electrolux ESF 65060 User Manual

14 electrolux

Select and start a washing program

Set the washing program with the door
ajar. The washing program only starts
after you close the door. Until then it is
possible to modify the settings.
1. Press the on/off button.
2. Make sure that the appliance is in setting
mode.
3. Press one of the program buttons. Refer
to the 'Washing programs' chart for pro-
gram details.
– The indicator light of the selected pro-
gram stays on. All other program indi-
cator lights go off.
– The digital display shows 3 horizontal
bars.
– The indicator lights for the set washing
program, start to flash.
4. Close the door.
– The washing program starts automati-
cally.
– Only the indicator light for the operating
program phase is on.
– The digital display shows 1 horizontal
bar and stays on for all the program
duration.
When the washing program operates,
you cannot change the program. Cancel
the washing program. Refer to 'Cancel-
ling a washing program'.
Select and start a washing program with
delay start
1. Press the on/off button.
2. Set a washing program.
3. Press the delay start button until the dig-
ital display shows the necessary delay
start of the washing program.
4. Close the door.
– The countdown starts. The display
shows remaining time to the start of the
washing program.
– When the countdown is completed,
the washing program starts automati-
cally.
If you open the door during the count-
down, this will interrupt the countdown.
When you close the door again, the
countdown continues from the point of
interruption.
Cancelling delay start
1. Press and hold at the same time function
buttons B and C buttons until all the pro-
gram lights come on and the digital dis-
play shows 3 horizontal bars.
– When you cancel delay start, you also
cancel the washing program.
2. Set a new washing program.
Warning! Only interrupt or cancel a
washing program if necessary.
Attention! Open the door carefully.
Hot steam and water can escape.
Interrupting a washing program
Open the door.
• The program stops.
Close the door.
• The program continues from the point of
interruption.
Cancelling a washing program
1. Press and hold at the same time function
buttons B and C buttons until all the pro-
gram lights come on and the digital dis-
play shows 3 horizontal bars.
2. Release the two buttons, the washing
program has been cancelled.
At this point, you can follow these steps:
1. Switch off the appliance.
2. set a new washing program.
Fill the detergent dispenser with detergent
before you set a new washing program.
End of the washing program
The washing program is complete when:
• The digital display goes off.
• The Ready indicator light comes on.
1. Switch off the appliance.
2. Open the door.
– For better drying results, keep the door
ajar for some minutes before you re-
move the dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are
easily damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
• There can be water on the sides and door
of the appliance. Stainless steel becomes
cool more quickly than the dishes.