Select And Start A Washing Program - Electrolux ESF68040 User Manual

To use normal detergent again:
1. Deactivate the multitab function.

SELECT AND START A WASHING PROGRAM

Follow these steps to set and start a wash-
ing program:
1. Switch on the appliance.
2. Set options (if required). Refer to 'Option
menu'.
3. Select the washing program by pressing
the scroll buttons until the desired pro-
gram is shown, then press OK/Start.
Refer to the 'Washing programs' chart
for program details.
4. Set the delay start (if required). Refer to
'Option menu'.
To start a washing program the appli-
ance must be in program selection
mode. If you are still in option set
mode, press OK/Start button to return
to program selection mode.
5. Press the OK/Start button. The washing
program or the delay start countdown
starts automatically.
If the rinse aid is required, the message
appears after pressing the OK/Start
button and the appliance will not start
automatically. Press the OK/Start but-
ton again.
When the washing program operates,
you cannot change the program. Can-
cel the washing program. Refer to
'Cancelling a washing program'.
If you open the door during the count-
down, it will interrupt the countdown.
When you close the door again, the
countdown continues from the point of
interruption.
Warning! Only interrupt or cancel a
washing program if necessary. Open
the door carefully. Hot steam and
water can escape.
Interrupting a washing program
Open the door.
• The program stops. The display shows
the message PLEASE CLOSE DOOR .
Close the door.
• The program continues from the point of
interruption.
2. Fill the rinse aid dispenser.
3. Adjust the rinse aid dosage.
Cancelling a washing program
1. Press the cancel button.
2. Follow the messages that the display
shows to cancel the washing program.
At this point, you can follow these steps:
1. Switch off the appliance.
2. Set a new washing program.
Fill the detergent dispenser with detergent
before you set a new washing program.
Cancelling a delay start
1. Press the cancel button.
2. The display shows the message CON-
FIRM CANCEL? .
3. Press the OK/Start button to confirm.
The set program will automatically start.
End of the washing program
The washing program is complete when:
• The appliance stops automatically.
• The audible signal for the end of the pro-
gram operates.
• The display shows the messages PRO-
GRAMME END and PLEASE SWITCH
OFF .
It can occur that the rinse aid message
shows in the display as on alternative
to PLEASE SWITCH OFF . You can
switch off the appliance in any case.
1. Switch off the appliance.
2. Open the door.
– For better drying results, keep the
door ajar for some minutes before
you remove the dishes.
Let the dishes cool down before you re-
move them from the appliance. Hot dishes
are easily damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
• There can be water on the sides and
door of the appliance. Stainless steel be-
comes cool more quickly than the dishes.
electrolux 13