Electrolux ESL 66010 User Manual page 6

6 electrolux
Water hardness is measured in equivalent
scales:
• mg/I (millimol per litre)
• ppm (parts per million),
• mmol/l (millimol per litre - international unit
for the hardness of water).
Water hardness
mg/l
910 - 1250 910 - 1250
760 - 909 760 - 909
650 - 759 650 - 759
510 - 649 510 - 649
400 - 509 400 - 509
330 - 399 330 - 399
260 - 329 260 - 329
190 - 259 190 - 259
70 - 189 70 - 189
< 70
1) No use of salt required.
You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at po-
sition 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.
Electronic adjustment
The dishwasher is factory set at lev-
el 5.
ppm mmol/l
9,1 - 12,5
7,6 - 9,0
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
3,3 - 3,9
2,6 - 3,2
1,9 - 2,5
0,7 - 1,8
< 70 < 0,7
Adjust the water softener in to the water
hardness in your area. If necessary, contact
your local water authority.
Water hardness setting
manually
2
2
2
2
2
2
1
1
1
1
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator lights for function buttons
B and C go off.
– The indicator light for function button A
continues to flash.
– The digital display shows the current
level.
– You can hear an audible signal.
Example: digital display shows
termittent audible signals = level 5.
6. Press the function button A one time to
increase the water softener level by one
step.
7. Continue pressing function button A until
the desired water softener level is ach-
ieved.
8. Press the on/off button to save the oper-
ation.
electronically
10
9
8
7
6
5
4
3
2
1)
1
/ 5 in-