Tips, Controls And General Information - Fiat 500X Owner's Handbook Manual

TIPS, CONTROLS
AND GENERAL
INFORMATION
ROAD SAFETY
Learn how to use the varied system
functions before starting to drive.
Read the instructions for the system
carefully before starting to drive.
197) 198)
RECEPTION
CONDITIONS
Reception conditions change
constantly while driving. Reception may
be interfered with by the presence
of mountains, buildings or bridges,
especially when you are far away from
the broadcaster.
IMPORTANT The volume may
be increased in comparison to
normal playing when receiving traffic
information.
CARE AND
MAINTENANCE
Observe the following precautions to
ensure the system is fully operational:
the display lens should not come into
contact with pointed or rigid objects
which could damage its surface; use a
soft, dry anti-static cloth to clean and
do not press.
do not use alcohol, petrol and
derived products to clean the
display lens, and make sure that the
Uconnect™ system is switched off
during cleaning.
prevent any liquid from entering the
system: this could damage it beyond
repair.
104) 105)
MULTIMEDIA DEVICES
IMPORTANT Some multimedia playing
devices may not be compatible with
the Uconnect™ system.
Only use devices (e.g. USB flash
drives) from safe sources on the car.
Devices from unknown sources could
contain software infected by viruses
which, if installed on the car, could
increase the vulnerability of the car's
electric/electronic systems to hacking.
ANTI-THEFT
PROTECTION
The system is equipped with an
anti-theft protection system based on
the exchange of information with the
electronic control unit (Body Computer)
in the car.
This guarantees maximum safety and
prevents the secret code from being
entered after the power supply has
been disconnected.
If the check has a positive outcome,
the system will start to operate,
whereas if the comparison codes are
not the same or if the electronic control
unit (Body Computer) is replaced,
the system will ask the user to enter
the secret code according to the
procedure described in the paragraph
below.
Entering the secret code
When the system is switched on, if the
code is requested, the display will show
"Please enter Anti-Theft Code" followed
by the screen showing a keypad to
enter the secret code.
The secret code is made up of four
digits, from 0 to 9: to insert the code,
turn the "BROWSE ENTER" right knob
and press to confirm.
After inserting the fourth digit, move
the cursor to "OK" and press the
"BROWSE ENTER" right knob: the
system will start to operate.
If an incorrect code is entered, the
system displays "Incorrect Code" to
notify the user of the need to enter the
correct code.
After the 3 available attempts to
enter the code, the system displays
"Incorrect Code. Radio locked. Please
wait for 30 minutes". After the text has
disappeared it is possible to start the
code entering procedure again.
225