Fiat 500X Owner's Handbook Manual page 21

Hide thumbs Also See for 500X:
Table of Contents

Advertisement

relation to the vehicle and the angle of
the backrest.
17
Height adjustment
Use the front part of the switch (A)
fig. 17 to modify the height and/or the
angle of the seat cushion.
Longitudinal adjustment
Push switch (A) forwards or backwards
to move the seat in the corresponding
direction.
Backrest angle adjustment
Push switch (B) forwards or backwards
to adjust the backrest in the
corresponding direction.
Electric lumbar adjustment
Use the joystick (C) to operate the
lumbar area device to obtain maximum
driving comfort.
IMPORTANT The electrical adjustment
is only allowed when the ignition device
is turned to MAR and for about 20
minutes after it is turned to STOP.
With the ignition device in the STOP
position, the electric adjustment of the
seats is immediately blocked when the
car is locked from the outside.
FRONT SEAT ELECTRIC
HEATING
(where provided)
With ignition device at MAR, press
buttons
fig. 18 on the dashboard.
F1B0018C
18
You can select two heating levels:
"minimum heating" : one orange LED
lit on the buttons;
"maximum heating" : two orange
LEDs lit on the buttons.
After selecting one heating level, you
need to wait for a few minutes until
warm air flows into the compartment.
When the "maximum heating" setting
is selected, the heater produces a
boosted heat level for the first minutes
of operation.
IMPORTANT To preserve the battery
charge, this function cannot be
activated when the engine is off.
Auto On Comfort
(where provided)
The electric heated driver seat
is switched on automatically to
"maximum heating" whenever the
engine is started and the outside
temperature is lower than 4.4°C.
This function can be activated and
deactivated using the Uconnect™
system Menu.
REAR SEATS
Partial extension of the luggage
compartment (1/3 or 2/3)
14)
6)
remove the rear shelf;
completely lower the rear seat head
F1B0751
restraints;
move the seat belt to the side,
making sure that it is fully extended and
not twisted;
operate release device (A) fig. 19 to
fold the required backrest section.
When the device is released, a red
mark becomes visible. Guide the
backrest into the folded position with
your hands.
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents